Contents In Box; Installation Requirements - Franke HT-400 Installation Manual

HT-400
Under Sink Heating Tank Installation Instructions and Use and Care Guide

CONTENTS IN BOX:

When you purchase the HT-400 heating tank- contents include:
1. Tank
2. Power Cable
3. Hose Clamp

INSTALLATION REQUIREMENTS

For best results, Franke recommends its products be installed by a licensed, professional plumber.
The installer should familiarize themselves with how this heating tank will be installed. Make certain
to observe all local plumbing and building codes during installation of this unit. Proper installation
is the responsibility of the installer. Water connections using push fittings DO NOT require any type
of sealing compounds to prevent leakage. Use of any sealing compounds in push fitting connections
will VOID THE PRODUCT WARRANTY.
TYPE OF FAUCET REQUIRED
Although this system should function with any "open vent" style dispensing faucet (see pg. 2) when
properly installed, Franke can only guarantee proper performance when this tank is paired with a
Franke dispensing faucet, so Franke strongly recommends using only genuine Franke dispensing
faucets with the HT-400 Heating Tank.
TOOLS AND MATERIALS REQUIRED (NOT PROVIDED)
1. Ruler or measuring tape
2. Pliers
3. Gloves
4. Safety glasses
5. Drip pan or bucket
IMPORTANT INFORMATION
This product is not intended to produce a continuous fl ow of hot water. This model will produce up to 60
cups of water per hour at approximately 208F (98C)+/-5. Due to high water temperature, for safety
reasons the tank is not under pressure. Consequently, there is a slight delay of water fl ow after the
faucet has been turned on. This is normal and indicates the tank is functioning properly.
4