Connecting To Power Supply - Stihl SE 62 Instruction Manual

Holders for power cord
Connect holder for power cord via
N
the support on the upper part of the
vacuum cleaner
Suction tube
1
Connect suction tubes (1) and (2)
N
SE 62
Mount suction tube holder
Slide the suction tube holder (1) via
N
the suction tube (distance A approx.
8 cm / 3.150 in.) and secure it with
the screw (2)
Fastening accessories
2
Fasten accessories on the holders
provided – as shown in picture.
2
1
A

Connecting to Power Supply

The voltage and frequency of the
machine (see rating plate) must match
the voltage and frequency of the power
connection.
The minimum fuse protection of the
power connection must comply with the
specifications – see "Specifications".
The machine must be connected to the
power supply via an earth-leakage
circuit breaker to disconnect the power
supply if the differential current to earth
exceeds 30 mA.
The power connection must correspond
to IEC 60364 and relevant national
regulations.
Extension Cords
Make sure your electrical cord set is in
good condition and suitable for outdoor
use. When using an extension cord, be
sure to use one heavy enough to carry
the current your product will draw. An
undersized extension cord may cause a
drop in line voltage resulting in loss of
power and overheating. The table below
shows the correct size (AWG) to use for
your machine (Cord types SJW or
SJTW) depending on cord length and
nameplate ampere rating. If in doubt,
use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
Cord length (ft) Wire gage (AWG)
50 16
100 14
150 12
English
7