HPE LSQM2MPUD0 Manual

Manual version: 6PW108-20180130
LSQM2MPUD0 management and route unit
1 Card identifier
The card identifier LSQM2MPUD0 is in the upper right corner of the front panel.
2 Specifications
IMPORTANT:
• The S7506E (non-PoE) does not support this card.
• Before installing the card, you must remove the protection cover from the card to ensure correct
installation.
• The 40G QSFP+ fiber module cannot be connected to a 10-Gbps SFP+ transceiver module
when the 40G QSFP+ fiber module is installed in this card.
Table 1 LSQM2MPUD0 specifications
Item
Flash
SDRAM (DDR3)
Card size (H × W × D)
Power consumption
Ports
Port speed
Transmission medium and max
transmission distance
Compatible device models
Applicable host software versions
Specifications
1 GB
4 GB
40 × 399 × 355 mm (1.57 × 15.71 × 13.98 in)
55 W to 96 W
•
1 x console port
•
1 x USB console port
•
4 x network management ports: 2 × 10/100/1000BASE-T copper
ports and 2 SFP fiber ports
•
2 x QSFP+ ports
•
1 x USB port
• Console port: ≤ 115200 bps (default: 9600 bps)
•
USB console port: ≤ 115200 bps (default: 9600 bps)
•
10/100/1000BASE-T copper port: 10/100/1000 Mbps, half/full
duplex
•
SFP fiber port: 1000 Mbps
•
QSFP+ fiber port: 40 Gbps
•
Console port: 15 m (49.21 ft) over ordinary asynchronous serial
port cables
•
USB console port: 10 m (32.81 ft) over USB-AB cables
•
10/100/1000BASE-T copper port: 100 m (328.1 ft) over Category
5 or higher twisted pair cables
•
SFP fiber port: see
•
QSFP+ fiber port: see
S7503E/S7506E/S7506E-V/S7510E
Version 7168 and later
i
Table 3
Table 4, and Table 5
BOM: 3123A0XN