Advertisement
3. MOUNT THE PROJECTOR ASSEMBLY TO THE PROJECTOR MOUNT
Place the projector assembly into the bayonet slots on the mount ( small end into large end) and slide backward until the safety
lever engages fig 5. Adjust the thumb screws to secure the mount to the projector. To remove loosen the thumb screws and lift the
safety lever, slide the unit forward and out.
NOTE: Some of the projector mount pieces are removed for a better view.
Fig 5
4. Alternate height
To convert to a 2 ½" length. Remove the 4 screws in fig 6. Using the 2 screws and 6 washer reassemble the unit as in fig 7.
Fig 6
Screw
Washer
Projector mount
Projector assembly
Fig 7
HEIGHT ADJUST
9" - 12"
Safety lever
2 washers
each side
5
Locking thumb screw
MIN HEIGHT 2 ½"
Advertisement
