Specifications - Campbell Hausfeld XT302000 Operating Instructions Manual

If water and/or oil can ruin your project, consider adding a filter or filter/regulator
◆
(F/R) to your system. ALSO, make sure to drain any condensate from your filter
AND compressor every time you use it—as much as daily!
◆ For best output, maintain pressure at the tool of 90 PSI.
◆ The longer your air hose the greater the pressure drop from compressor to tool.
If you are using a hose longer than 50 feet, consider upgrading to a 1/2 inch ID air
hose to ensure proper tool pressure.
◆ Failure to lubricate and maintain your air tools properly will dramatically shorten
their life. Use oil every time you use your air tool to lubricate, clean and inhibit rust
in one step. Campbell Hausfeld sells air tool oil under part number ST1270.

SPECIFICATIONS

Maximum PSI
CFM no load 100% duty
SCFM no load 100% duty
Air Compressor Recommendation
RPM (free speed)
Orbit Diameter
Sanding Pad Size
Pad Thread Size
Variable Speed
Air Inlet
Minimum Hose Size
Housing Material
Tool Weight
Tool Length
Tool Height
Tool Width
BEST PRACTICES
2
XT302000
90
2.1 CFM @ 90 PSI
14.9 SCFM @ 90 PSI
26 gallon
10,000
5 mm
6 inch
5/16-24
Yes
1/4 inch NPT (F)
3/8 inch
Composite
2.0 Lbs.
9-1/2 inch
3-1/2 inch
5-7/8 inch