Kingfisher 2525 Ownersmanual page 52

NOTE: Always ensure that there is sufficient water in the fresh water tank to allow water
to be drawn by the pressure pump prior to operating the shower system. Running the
system dry may cause severe damage and render the system inoperable.
If the pump fails to activate:

Confirm that there is sufficient water in the water tank

Confirm that the battery switch is turned on

Confirm that the battery system is fully charged and functioning and that all wires
leading to the batteries are secured firmly to the battery posts

Check that the main 30 amp fuse and the fuse under the dash have not blown

Once the above has been checked, if the shower pump is still not working, consult a
Kingfisher dealer
Hot water tank
The hot water tank is located behind the helm seat box in the 28' / 30' models and below
the rear starboard side countertop in the 25' / 27' models. The fresh water in the hot
water tank can be heater either by the Espar Hydronic system or by AC shore power.
The hot water tank is hard wired into the shore power system and will automatically run
off of the shore power source once that the power supply is connected.
Refer to the hot water tank manufacturer's owners manual for operating
and safety instructions.
KINGFISHER
O W N E R ' S M A N U A L
Pressure pump switch
w w w . k i n g f i s h e r b o a t s . c o m
49