Kingfisher 2525 Ownersmanual page 37

Heater (Optional):
25', 27', 28' and 30' boats may be fitted with an optional heater. The dash heater switch
will operate the dashboard heater fan. The rear bus heater which is located below the port
side countertop is operated by the Accessory 1 switch.
Blower:
All inboard models are fitted with an engine compartment blower. The blower is controlled
by the dash mounted switch.
Cabin lights:
The cabin lights are controlled by the cabin light switch.
Deck lights:
The deck light illuminates the cockpit area of the boat and is operated by the deck light
switch.
Wipers:
The wipers are controlled by operating their corresponding dash mounted switches.
Shore Power System (Optional):
This option is available on 25', 27', 28' and 30' Models. The shore power breaker panel is
located to the starboard side of the helm seat.
The shore power option enables the boat user to run the boats electrical components
without the use of the internal battery system. To hook up to shore power:
These lights are located adjacent to the panel's breakers. If reverse polarity is
indicated immediately disconnect the shore power cord, and consult an authorized
Kingfisher dealer.
A green light on the shore power breaker panel will be illuminated when the system is
operational. Each breaker in the breaker panel is clearly labelled with its intended use.
If a component or appliance trips the breaker:
KINGFISHER
O W N E R ' S M A N U A L
w w w . k i n g f i s h e r b o a t s . c o m
34

Ensure that the AC main 30 amp
switch on the shore power panel is
turned off.

Plug the shore power cord into the
boat's shore power socket. The
boat's plug in socket is located
below the starboard side gunnel in
the top side tray.

Plug the shore power cord into the
dock power supply.

Turn on the shore panel AC main
30 amp switch.

Check the shore power panel for
reverse polarity warning lights.