CleaningTheShaver - Panasonic ES‑LV64 Manual

Cleaning the shaver
1. Disconnect the cord from the
shaver.
2. Apply some hand soap and some
water to the system outer foil.
3. Rotate the lock ring to unlock
the power switch.
4. Press the power switch for more
than 2 seconds to activate the
sonic vibration cleaning mode.
• The battery capacity lamps
blink in order.
• After about 20 seconds, it will
be automatically turned off, or
you can turn it off by pressing
the power switch.
5. Remove the outer foil section
and press the power switch for
more than 2 seconds to activate
the sonic vibration cleaning
mode and clean it with running
water.
6. Wipe off any drops of water with
a dry cloth.
7. Dry the outer foil section and the
shaver completely.
8. Attach the outer foil section to
the shaver.
9. Lubricate the shaver.
ES-LV64_CH.indb 29
4
Warning
Disconnect the cord from the shaver before
cleaning it in water to prevent electric shock.
Lubrication
To maintain shaving comfort for a long time, it is
5
recommended that the oil provided with the shaver is
used.
1. Switch off the shaver.
2. Apply one drop of oil to each
of the outer foils.
3. Raise the trimmer and apply
a drop of oil.
4. Switch the shaver on, and run
it for approximately five
7
seconds.
5. Switch off the shaver, and wipe off any excess oil
from the outer foils with a soft cloth.
Cleaning with the brush
►Cleaning with the long brush
Clean the system outer
foil (a), the shaver body
(b) and the trimmer (c)
using the long brush.
The mark on the left means suitable for
cleaning under an open water tap.
2

3
 
29
2014/03/26 15:05:16