Table of Contents
Advertisement
Parts identification
Front
Back
Main unit
Nozzle release button
" 开关 " (power) switch
" 选择 " (mode) switch
Mode indicator
Charging indicator
Ventilation hole
Suction hose
Filter
Water tank
Water tank cap
EWM1311_CH.indb
25
Charger (RE8-53)
Charging section
Cord
Power plug
> Nozzle stands
? Screw holes for wall
mounting
The charger can be
mounted on a wall
using two wood screws.
Nozzle (x2)
@ Nozzle
Identification ring
Nozzle handle
Accessories
2 screws
Note
There may be moisture inside the main unit (water
tank and suction hose) left from the distilled water
used for product testing.
Charging
► On the bathroom countertop or a shelf
1. Place the cord in the right, left or
center cord guide, depending on
where the charger will be placed.
2. Place the charger on a secure, level
surface.
3. Plug in the power plug.
1
1
Insert main unit so it stands
upright in the charging section�
The charging indicator will light up.
• Be sure to place the main unit upright.
If the main unit is tilted or not in direct
contact with the charger, the main unit
may not charge properly.
• Charging is completed in about 15 hours.
• The lamp does not go off even when
charging ends.
• The main unit will provide an operation
time of approximately 15 minutes of
use when the battery is fully charged.
(The operating duration will become
shorter as the batteries get older.)
25
2018/11/16
17:07:50
Advertisement
Chapters
Table of Contents
