Operation - Honeywell HZ-510 Series Operating And Safety Instructions Manual

10. Warning – This appliance has a polarized plug
(one blade is wider than the other). To reduce
the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician. DO NOT attempt to defeat this
safety feature.
11. Warning – This heater is for use on 120
volts. The cord has a plug as shown at A in
the figure below. An adapter as shown at C is
available for connecting three-blade grounding-
type plugs to two slot receptacles. The green
grounding lug extending from the adapter must
be connected to a permanent ground such as
a properly grounded outlet box B. The adapter
should not be used if a three-slot grounded
receptacle is available. DO NOT circumvent
the safety features of the grounding-type plug.
DO NOT modify the power cord.
12. Warning – It is normal for the plug to feel
warm to the touch; however, a loose fit
between the AC outlet (receptacle) and plug
may cause overheating and distortion of the
plug. Contact a qualified electrician to replace
loose or worn outlet.
13. Warning – To disconnect the heater, first turn
off the product, then grip the plug body and
pull it from the wall outlet. DO NOT pull by the
cord.
14. Warning – DO NOT insert or allow foreign
objects to enter any ventilation or exhaust
opening as this may cause an electric shock
or fire, or damage the heater.
15. Warning – To prevent a possible fire, DO NOT
block air intakes or exhaust in any manner.
DO NOT use on soft surfaces, like a bed,
or where openings may become blocked.
16. Warning – A heater has hot and arcing or
sparking parts inside. DO NOT use it in areas
where gasoline, paint or flammable liquids
are used or stored.
A
Fig. 1
2
17. Warning – Use this heater only as described in
this manual. Any other use not recommended
by the manufacturer may cause fire, electric
shock, or injury to persons.
18. Warning – Always plug heater directly into
a wall outlet/receptacle. DO NOT use with
an extension cord or relocatable power tap
(outlet/power strip).
19. Warning – NEVER tamper with this product
or attempt to fix it. Any tampering with, or
modification of this product can result in
serious injury, death, or fire. Risk of electric
shock. DO NOT open. There are no user
serviceable parts inside.
20. Warning – DO NOT remove product labels
that contain warnings or safety instruction.
21. Caution – The output of this heater may vary
and its temperature may become intense
enough to burn exposed skin. Use of this
heater is not recommended for persons with
reduced sensitivity to heat or an inability to
react to avoid burns.
22. Caution – Before cleaning, or storage, or when
not in use, turn the product's controls to the
OFF position and unplug the heater from the
electrical outlet and allow to cool.
23. Caution – Place the heater on a firm, level,
open surface free from obstructions and at
least 3 feet (0.9 m) away from any combustible
materials. DO NOT use on an unstable surface
such as bedding or deep carpeting. Be sure
the heater is not in a position where it may
be tripped over by small children or pets.
24. Caution – If your home has aluminum
wiring have a licensed electrician check your
receptacle's connections. When using a 1500
watt heater, aluminum wire connections can
cause a safety issue.
SAVE THESE
25.
INSTRUCTIONS
B
COVER OF
GROUNDED
OUTLET BOX
C
SET-UP
• Place the heater on a firm, level, open surface free from obstructions and at least 3 ft. (0.9m)
away from any combustible materials.
• DO NOT use on an unstable surface such as bedding or deep carpeting.
• BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY SMALL
CHILDREN OR PETS.
• With the Power knob in the OFF position, plug the heater into a grounded 120V outlet suitable
for a 3-prong plug (Fig.1).
OUTPUT DIRECTION
This heater is equipped with adjustable front legs that allow you to adjust
the heat output angle up and down.
Adjust the angle up or down by turning the lever located on the side of
the heater counterclockwise to tilt up. Turn the lever clockwise to lower
the output angle. (Fig. 2).

OPERATION

• Place the heater on a firm, level, open surface free from obstructions
and at least 3 ft. (0.9m) away from any combustible materials. DO NOT
use on an unstable surface such as bedding or deep carpeting. Be sure
the heater is not in a position where it may be tripped over by small
children or pets. The heater's rubber feet will hold it firmly in position.
• With the Power knob in the OFF position, plug the heater into a grounded
120V outlet suitable for a 3-prong plug (Fig. 3). DO NOT FORCE THE
POLARIZED PLUG INTO THE OUTLET; it will only fit one way.
• Turn the Thermostat fully clockwise to its highest position.
• Use the Power knob to turn the heater on to LOW (750W) or HIGH
(1500W). The power light will illuminate.
• When the room reaches a comfortable temperature, slowly turn the Thermostat control counter-
clockwise until the heater goes off. This is the point at which the Thermostat setting equals the room
temperature. At this setting, the Thermostat will automatically turn the heater on and off to maintain
this selected temperature.
• Turn the Power knob to OFF and unplug the heater when you are finished using it.
To operate the fan:
• Turn the Power knob to FAN and the Thermostat knob to its highest setting to use the unit as
an air circulator without heat.
NOTE: THIS PRODUCT IS EQUIPPED WITH A SAFEGUARD
(FIG. 3). WHEN THE SAFEGUARD ™ ALERT BADGE LOCATED ON THE TOP OF THE GRILL CHANGES
FROM BLACK TO RED THE GRILL IS HOT TO THE TOUCH. DO NOT TOUCH THE GRILL UNTIL THE UNIT
HAS BEEN TURNED OFF AND THE SAFEGUARD
Fig. 2
™
ALERT HEAT INDICATOR BADGE
™ ALERT BADGE HAS TURNED BACK TO BLACK.
Fig. 3
3