Optional Automatic; Removing The Base Grille; The Light Bulb; Ice Maker - Whirlpool ET22ZK Use & Care Manual

Changing the light bulb.. .
Before removing the light shield for cleanrng or for
replacrng the bulb,
unplug the refrigerator. Use
light bulb behind light shield:
opphonce buibs on/y
1. Push lightly on top center of the light shield until the
notched tab unhooks from the control panel.
2. Pull down on the shield until the tab clears the con-
trol panel.
3. Lift the back hooks out of the slots.
Push in the Center;
4. Replace with a 40.watt appliance bulb
5 Replace light shield in reverse order.
Optional automatic ice maker.. .
i L
ower Slgnal
Arm to Start It.
daise Signal
Arm to Stop Ice Maker.
If you have the automatic ice maker accessory or
plan to add one later [Part No. ECKMF-6). there are
a few things you WIII want to know:
l
The ON/OFF lever IS a wire signal arm.
Downfor making ice automatically,
Up. .to shut off the ice maker
l
Shake the brn occasionally to keep cubes sepa-
rated, and to obtarn increased storage capacity.
l
It IS normal for ice crescents to be attached by a
corner. They will break apart easily.
l
Ycu will hear water running when ice maker
IS
working. You'll hear ice fall into the bin. Don't let
these sounds bother you.
l
The Ice maker will not operate until the freezer is
cold enough to make ice. This can take overnight.
l
Because of new plumbing ccnnectrons, the first
ice may be discolored or off-flavored Discard the
first few batches of Ice.
l
If ice is not being made fast enough and more ice
is needed, turn the Temperature Control toward a
higher number. Wait a day and, if necessary, turn
the Air Control toward A.
l
If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
posrtron.
l
If cubes are stored too long, they may develop an
off-flavor .Irke stale water. Throw them away. They
WIII be replaced. Cubes in the ice bin can also
become smaller by evaporation
Removing the base grille.. .
l
Open the door
l
Pull grille outwards as shown.
SuDDort Tabs
l
Do not remove Tech sheet
fastened behind grrlle
To replace:
l
Line up grille support tabs with metal
clips
l
Push firmly to snap Into place
l
Close the door