Table of Contents
Advertisement
Changing the light bulbs...
3. Replace with a 40-watt appliance
bulb.
Removing the base grille...
To remove the grille:
r
METAL CLIPS
SUPPORT TABS
SUPPORT TABS
.
-
1. Open the doors.
To replace
the grille:
2. Pull grille outwards as shown.
1. Line up grille support tabs with metal clips.
3. Do not remove Tech sheet fastened
behind
2. Push firmly to snap into place.
orille
3. Close the doors.
Ice cube trays...
(Model ETPOGK)
If cubes are not used, they may shrink. The mov-
ing cold air starts a slow evaporation.
The longer
cubes are stored, the smaller they get.
To remove Ice:
1. Hold tray at both ends.
2. Slightly twist.
Automatic ice maker.. .
If you have Model ET20VM and have the auto-
matic ice maker accessory, or if you have Model
ET20VK and plan to add one later (Part No.
ECKMF-831, there are a few things you will want to
know:
l
The ON/OFF lever is a wire signal arm.
Downfor
making ice automatically
Up...to shut off the ice maker.
l
Shake the bin occasionally
to keep cubes sepa-
rated, and to obtain increased storage capacity.
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily
l
You will hear water running when ice maker is
working. You'll hear ice fall into the bin. Don't let
these sounds bother you.
l
The ice maker will not operate until the freezer
is cold
enough
to make ice. This can take
overnight.
l
Because of new plumbing
connections, the first
ice may be discolored
or off-flavored. Discard
the first few batches of ice.
l
If ice is not being made fast enough and more
ice is needed, turn the Refrigerator Control to-
ward a higher number. Wait a day and, if neces-
sary, turn the Freezer Control toward A.
l
If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position.
l
If cubes are stored too long, they may develop
an off-flavor...like stale water. Throw them away
They will be replaced. Cubes in the ice bin can
also become smaller by evaporation.
l
Good water quality
is important
for good ice
quality It is not recommended
that the ice maker
be connected
to a softened water supply. Water
softener chemicals
such as salt from a malfunc-
tioning
softener can damage
the ice maker
mold and lead to poor quality ice. If a softened
water supply cannot be avoided, then it is impor-
tant that the water softener be well maintained
and operating
properly.
7
Advertisement
Table of Contents
