Advertisement
Luke
II Keypad Lighting
®
5. If not already connected in step 2, connect the small connector to the keypad lighting tail
connector.
6. If the RFID cable was previously detached for access, re-attach it and install a new cable tie to
the anchor.
7. The keypad light cable can also be anchored to the LCD backlight cable with a cable tie.
8. Complete the lighting installation by installing the diffuser on top of the mounting screws and
lighting array.
9. Restore power to your pay station. The keypad light will activate once the pay station starts up.
The light will turn off when the pay station goes into sleep mode and will turn on again when a
key on the keypad is pressed.
T2 Systems, Inc.
|
T2systems.com
Installation Guide
8
Advertisement
