Advertisement
Luke
II Keypad Lighting
®
2x Screws 8-18 x 3/4in FH Phil SS Drilling Tip
1x Grommet, Rubber for 1/2in Hole
2x Small cable ties
Steps to Take:
1. Install the grommet into the hole on the door panel.
2. Carefully insert the tail end of the flex PCB lighting assembly into the 3/8in hole in the cast, and
feed it through the grommet.
a. It might be easier to feed the mating cable connector through the grommet and out of the
hole in the cast, attach the lighting assembly, and then carefully guide the PCB tail into the
hole and through the grommet.
b. Be sure not to twist or crease the flex PCB as it is being guided through the holes.
T2 Systems, Inc.
|
T2systems.com
Installation Guide
6
Advertisement
