Table of Contents
Advertisement
Quality
All EntelliGuard R circuit breakers have been designed and manufactured to ANSI standards. The design was
based on the original requirements of the legacy switchgear and breakers. The product is manufactured in
Burlington, Iowa; and is inspected using some of the same master gauges used on the legacy AK, AKR
breakers to confirm electrical and mechanical performance, including rejections-features.
Information Label
On the side wall of each circuit breaker there is a factory-assembled label that details all features included
on both the circuit breaker and on the trip unit.
Product and Catalog Serial Numbers
Product and catalog serial numbers should be kept handy when communicating about the circuit breaker.
Each circuit breaker has a unique serial number located on the left side (viewed from front) of the front
fascia.
Remove Circuit Breaker from Container
Inspect
1. Inspect the shipping container for obvious signs of rough handling and/or external damage incurred
during transportation.
2. Record any observed damage for reporting to the carrier. Ensure all recorded reports and claims include
the order number and name plate information.
3. Remove the banding straps and lift the top cover.
4. Remove all packaging material.
5. Remove all product documentation and store properly.
6. Unscrew the mounting screws that fasten the circuit breaker to the bottom of the shipping pallet and
remove the circuit breaker.
Store Circuit Breaker
If you decide not to install the Retrofill breaker until a later time, then you can store it away for installing
it later.
EntelliGuard R Circuit Breaker Retrofill AKD-8 Installation Manual
20
PRODUCT DAMAGE
• Do not store circuit breaker in corrosive
environments above LC1 (sea salt mist) and
G1 as per ANSI/ISA-S71.04-1985.
• Ensure circuit breakers are stored in a
clean, dry location, in their original
packaging.
• Failure to comply with these instructions
may result in product damage.
DEH41549 R05
Hide quick links:
Advertisement
Table of Contents
