Changing The Light Bulb - Whirlpool ET14GK Use And Care Manual

Solving common ice maker problems
PROBLEM POSSIBLE CAUSE/SOLUTION
Ice crescents attached
l
This is normal. They break apart easily. Shake bin occasion-
at corners
ally to keep cubes separated.
Ice maker will not
operate
or
ice is not
made fast enough
l
ON/OFF lever is in the OFF (up) position. Lower lever to the
ON (down) position.
l
Freezer is not cold enough. Adjust temperature control and
wait 24 hours.
Off-taste or odor in ice
l
New plumbing connections can cause discolored or off-
flavored ice. Discard the first few batches of ice.
l
Cubes are stored too long. Throw them away and make a
new supply.
l
Foods in freezer are not wrapped properly. See "Food
Storage Guide" on pages 16 and 17.
l
Freezer and ice bin need to be cleaned. See pages 13
and 14.
Changing the light bulb
Electrical Shock Hazard
Before removing a light bulb, either
unplug the refrigerator or disconnect
the electricity leading to the refrigera-
tor at the main power supply. Turning
the Temperature Control to the OFF
position does not disconnect the
refrigerator from the power supply.
Failure to do so could result in electri-
cal shock or personal injury.
To change the refrigerator light:
1.
Disconnect refrigerator from power
supply.
2. Reach behind the Control Panel to
remove bulb.
3. Replace with a 40-watt appliance bulb.
4. Reconnect refrigerator to power supply.
NOTE:
Not all commercial appliance bulbs
will fit your refrigerator. Be sure to replace a
bulb with one of the same size, wattage and
shape.
11