Advertisement
I I I .
The SilverBoom 300 can be installed in either side of
your vehicle. The illustrations demonstrate installation on
the right side.
NOTE: Most roads have a crown to help with wa-
ter runoff. However, if the crown is severe enough,
it may cause difficulty getting your mobility device
into the vehicle. In this case, it may be better to
install the lift on the left side.
DETERMINE L-BASE LOCATION
1. Assemble the L-Base. See figure 1. For optimal
use, insert the base extensions into the L-base at
their farthest extension point and install the hardware
(nuts and bolts). The base extensions can be ad-
justed to accommodate obstructions.
NOTE: Always insert the bolt from the inside of
the L-base. This allows the base extensions to be
properly tightened without rattling.
2. Before permanently installing the lift, place the L-
base inside your vehicle in the area in which you in-
tend to install it. See figure 2 for L-base positioning
in vehicles with hatchbacks, or figure 3 for trunk
installation.
NOTE: Positioning the L-base close to the rear
allows the boom-arm to stay as short as possible;
this enables the boom-arm to swing freely without
making contact with the motor vehicle.
VEHICLES WITH TRUNKS
Position the L-base as shown in figure 3. You may
need to situate the L-base so the wheel well does not
interfere with the L-base extensions. Ensure there is
adequate room for a mobility device to comfortably fit
into the trunk.
8
I N S T A L L A T I O N
BASE EXTENSIONS
Figure 1. L-Base Extensions
Figure 2. L-Base (Hatchback Installation)
Figure 3. L-Base (Trunk Installation)
L-BASE
BOLT 55 MM (2.5")
NUT
WHEEL WELL
SilverBoom 300
Advertisement
