Advertisement
I I I . I N S T A L L A T I O N
7. Place the L-base cap over the L-base and secure it with the supplied screws. See figure 10.
8. Reinstall the upper post.
9. Reinstall the motor housing and make adjustments as necessary.
The lift is now fully assembled. See figure 11.
PHILLIPS HEAD SCREW 10 MM
L-BASE CAP
Figure 10. L-Base Cap Installation
ELECTRICAL WIRING INSTALLATION
1. Route the lift's long power wire (starting at the lift) through the interior of the vehicle until you reach the
automobile battery. See figure 12. Conceal the wire behind or under the interior panels (there should be
existing holes). Be certain that the wire is protected with a rubber grommet when passing it through the metal
panels and into the engine compartment. Inside the engine compartment, secure the wire to the firewall and the
inner fender with the supplied plastic wire ties. Use care not to cause abrasions to the power wire. It is
important to secure the power wire at various points along its run.
2. Insert the red positive (+) lead on the power wire into the spliced end of the red positive (+) battery lead, then
crimp the splice to secure the wire.
3. Connect the red positive (+) battery lead to the positive (+) battery terminal and the black negative (-) ground
wire to the negative (-) battery terminal.
WARNING! The red positive (+) wire must be connected directly to the positive (+)
battery terminal.
WARNING! The black negative (-) wire must be connected directly to the negative (-)
battery terminal.
4. Connect the harness extending from the motor housing to the harness coming from the battery (black to black
and red to red).
12
MOTOR HOUSING
UPPER POST
L-BASE CAP
L-BASE
T-BAR
Figure 11. Fully Assembled Lift
SilverBoom 300
Advertisement
