Advertisement
LIFTING THE MOBILITY DEVICE
WARNING! Before operating the SilverBoom
300 for the first time, be absolutely sure
you have the proper docking device for your
mobility device.
1. Prepare your mobility device for transport. Ensure that
the power is off or key is removed and properly secure
the batteries. You may also need to lower the tiller and/or
remove the seat.
2. Position your mobility device on the ground behind the
installed lift. Be sure that there is ample space between
the mobility device and the vehicle bumper to ensure
that the mobility device will not hit the bumper while
being raised. If the mobility device is too far from the
vehicle's bumper, the mobility device will be dragged
when attempting to lift it.
3. Position the boom-arm over the mobility device.
4. Operate the lift (via the hand control see figure 13) in
the downward direction until the lifting hook reaches the
T-bar. The lift strap should drop straight down to the T-
bar. See figure 14.
WARNING! Inspect the lifting strap before
each use for twisting, fraying, and signs
of wear.
" Keep tension on the lifting strap with your free hand
when lowering the lifting hook.
" Lower the lifting hook only to the T-bar of the dock-
ing device.
WARNING! Do not extend the lifting strap
past the warning label located on it. See
figure 15.
5. Place the lifting hook onto the docking device T-bar. See
figure 14.
6. Operate the lift in the upward direction.
WARNING! Pinch/Crush Hazard! Always
keep hands clear of the lifting strap while
the SilverBoom 300 is lifting/lowering a
mobility device. The operator of the lift
should stand a safe distance away from
the mobility device being lifted/lowered
to ensure that feet are never positioned
under a raised mobility device.
14
I V .
O P E R A T I O N
PRESS TO OPERATE LIFT IN A
DOWNWARD DIRECTION
PRESS TO OPERATE LIFT
IN AN UPWARD DIRECTION
Figure 13. Hand Control
DOCKING DEVICE T-BAR
LIFTING HOOK
Figure 14. Lifting Hook Placement
Figure 15. Lifting Strap Warning Label
SilverBoom 300
Advertisement
