Changing The Light Bulbs; Removing The Base Grille; Reversing The Door Swing; Ice Cube Trays - Whirlpool EM8GK Use & Care Manual

Using Your Refrigerator
Continued
Meta! clips
Defrost pan
I
Electrical Shock Hazard
I
Before removing a light bulb, either unplug
the refrigerator or disconnect the electricity
leading to the refrigerator at the main power
supply. Shock and injury can occur if elec-
tricity remains connected.
To change refrigerator light:
1. Disconnect refrigerator from power supply.
2. Reach behind the Control Console to fmd
bulb(s).
3. Remove bulb.
4. Replace with a 40-watt appliance bulb
5. Reconnect power supply
NOTE: Not all commercial appliance bulbs
WIII IIt
your refngerator. Be sure to replace bulb with one
of the same size and shape.
Removing the base grille
(Models ETZOGM, ETPOGK and ETSONK)
To remove the grille:
1. Open the door.
2. Pull grille out.
3. Do not remove Tech Sheet fastened
behind grille.
To replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the door.
See cleaning instructions for defrost pan and
condenser coils on page 14.
Reversing the door swing
You can change the hinges on your refngerator so
the doors open the other way. Refer to the Instruc-
tions sheet included with your refngerator.
Ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation. The
longer cubes are stored, the smaller they get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
10