RSi Smartcanopy EVO Fitment Instructions
Toyota hilux dc
Hide thumbs
Also See for EVO:
- Assembly instructions manual (9 pages) ,
- Fitment instructions (9 pages) ,
- Assembly instructions manual (9 pages)
Related Manuals for RSi Smartcanopy EVO
Summary of Contents for RSi Smartcanopy EVO
- Page 1 FITMENT INSTRUCTIONS TOYOTA HILUX DC PLEASE ENSURE TO READ FITMENT INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL. LIKE SHARE FOLLOW DOCUMENT REVISION 1.
- Page 2 FITMENT KIT CONTENTS FITMENT KIT CONTENT (HARDWARE) DESCRIPTION EXAMPLE Set Screw M8 x 30 M8 Nyloc Nut M8 Square Weld Nut M8 X 20 Flat Washers M8 X 16 Flat Washers M8 X 25 Flat Washers M8 Spring Washer FITMENT KIT CONTENT (COMPONENTS) DESCRIPTION EXAMPLE Front Mount Bracket...
- Page 3 2. ONLY USE THE HARDW ARE PROVIDED IN THE FITMENT KIT OUTLINED ON THE PAGE BEFORE. 3. HANDLE ALL RSI SMARTCANOPY FITMENT COMPONENTS WITH CARE UPON UNPACKING. 4. IT IS RECOMMENDED THAT THE MINIMUM OF FOUR PEOPLE ARE USED TO LIFT THE RSI SMARTCANOPY. 5. NEVER USE ACETONE ON PAINTWORK.
- Page 4 FITMENT OF THE RSI SMARTCANOPY TO VEHICLE STEP 1. POSITION THE FRONT LEFT HAND SIDE BRACKET IN PLACE AND USE THE HARDWARE DEPICTED BELOW TO HAND FASTEN THE FRONT LEFT HAND SIDE MOUNTING BRACKET. FOUR 2. WORK WITH CAUTION TO PREVENT UNNECESSARY DAMAGE.
- Page 5 FITMENT OF THE RSI SMARTCANOPY TO VEHICLE STEP 1. PLACE THE RSI SMARTCANOPY ONTO THE LOAD BIN. 2. MAKE SURE THE RSI SMARTCANOPY IS IN ITS CORRECT POSITION BY LINING UP THE SLOTS ON THE RSI SMARTCANOPY WITH THE SLOTS ON THE MOUNTING BRACKET. FIVE 3.
- Page 6 FITMENT OF THE RSI SMARTCANOPY TO VEHICLE STEP ONLY REQUIRED WHEN FITTING ROOF MOUNTED ACCESSORIES 1. SLIDE M8 WELDNUTS INTO ROOF RAILS. 2. BOLT ROOF MOUNTED ACCESSORIES TO THE WELDNUT CLAMPING THE ACCESSORIES DOWN. M8 WELDNUTS SLIDE INTO ROOF RAILS WHEN BOLTING DOWN ROOF MOUNTED ACCESSORIES.
- Page 7 FITMENT OF THE RSI SMARTCANOPY TO VEHICLE STEP 1. NEATLY RUN BRAKE LIGHT HARNESS ON THE LEFT HAND SIDE INTERIOR OF THE CANOPY. SEVEN USE PICTURE IN FITMENT KIT. STEP 2. BEFORE FITTING PLUGS ONTO LIGHT HARNESS,THREAD THE HARNESS THROUGH EIGHT THE ACCESS HOLE ON THE LEFT HAND SIDE THE VEHICLES BIN.
- Page 8 FITMENT OF THE RSI SMARTCANOPY TO VEHICLE STEP 3. FIT CONNECTING PLUG ONTO THE END OF THE HARNESS OF THE REAR DOOR HIGH LEVEL BRAKE LIGHT. NINE PLEASE ENSURE PLUG IS CONNECTED IN CORRECT ORIENTATION.(POSITIVE TO POSITIVE AND NEGATIVE TO NEGATIVE)
- Page 9 FITMENT OF THE RSI SMARTCANOPY TO VEHICLE STEP 1. USE WIRE HARNESS FROM KIT SUPPLIED, RECONNECT TAIL LIGHT ELEVEN PLUG TO HARNESS Wiring Harness Supplied STEP 1. PLUG REAR BRAKE LIGHT INTO THE HARNESS. TWELVE Ensure Positive Is Connected To Positive (RED)