Advertisement
Micromatic LLC
525 Berne St
Berne, IN 46711
1-260-589-2136 x3211
customerservice@micromaticllc.com
TIPPER DIMENSIONS – SHOWN IN THREE (3) POSITIONS
Recommend temporary mounting and performing a test
fit and can pick up before fully welding mounting plate
into place.
Note: Be sure and account for chassis sag when loaded.
➢ Each waste cart manufacturer has slightly different dimensions for contact points.
➢ When carrying out tipper installation onto truck, account for height changing when
the truck is in loaded and unloaded conditions. Expect approximately 1" of sag.
➢ During installation, verify operation throughout full range of motion and ensure
waste cart is securely retained during the dump cycle and released when dropped
to the ground. If necessary, adjust the lifting saddle, arm position, and/or position
of tipper on the truck.
26-18-1006 rev.-
Page 6 of 10
RotacTippers.com
Model: LONG ARM
Advertisement
