Table of Contents
Advertisement
8
Checking the Gearbox Oil
No Parts Required
Procedure
Ensure that the gearbox has the correct amount of oil;
refer to
Checking the Lubricant in the Gearbox (page
19).
9
Checking the Caster Tire
Pressure
No Parts Required
Procedure
Ensure that the caster tires are filled to 2 to 3.5 bar (30
to 50 psi); refer to
Checking the Caster Tire Pressure
(page
23).
10
Greasing the Machine
No Parts Required
Procedure
Grease the machine before the first operation; refer
to
Lubricating the Cutting Unit (page
properly grease the machine will result in premature
failure of critical parts.
Product Overview
Specifications
Note:
change without notice.
Width
of Cut
Height
of Cut
Net
Weight
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
18). Failure to
12
Specifications and design are subject to
1.52 m (60 inches)
Adjustable from 19 to 102 mm (3/4 to 4 inches) in 13
mm (1/2 inch) increments
260 kg (573 lb)
Advertisement
Table of Contents
