Advertisement
Quick Links
Installation Instructions
IMPORTANT:
Read and save these
instructions.
IMPORTANT:
Installer: Leave Installation Instructions with the homeowner.
Homeowner: Keep Installation Instructions for future reference.
Save Installation Instructions for local electrical inspector's use.
120-volt
50-Hz
Washer
Part No. 8318342
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on
your appliance. Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you
and others.
All safety messages will follow the safety alert symbol and either the word
"DANGER" or "WARNING". These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to
reduce the chance of injury, and tell you what can happen if the instructions
are not followed.
Parts supplied:
Remove parts from packages.
Check that all parts were included.
literature package
2 inlet hoses
1 small clamp
parts
2 hose clamps
bag
Tools needed:
pliers
scissors
You can be killed or seriously injured if
you don't immediately follow instructions.
You can be killed or seriously injured if
you don't follow instructions.
1 drain
hose
1 hose
extension
4 flat water
hose washers
2 front leveling legs
with nuts
utility
level
knife
adjustable wrench or
9/16" open-end
wrench
Advertisement
Related Manuals for Whirlpool 2DLSQ7533JQ4
Summary of Contents for Whirlpool 2DLSQ7533JQ4
- Page 1 Installation Instructions Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
-
Page 2: Location Of Washer
Before you start... Location of washer: Check location where washer will be installed. Make sure you have everything necessary for correct installation. Proper installation is your responsibility. Recessed area instructions Hot and cold water faucets: Should be within 3-1/2 feet (106.7 cm) of upper right hand corner of washer cabinet (if not, see chart below). -
Page 3: Electrical Requirements
Electrical requirements WARNING If codes permit and a separate ground wire is used, it is GROUNDING INSTRUCTIONS recommended that a qualified electrician determine that the For a grounded, cord-connected washer: ground path is adequate. This washer must be grounded. In the event of malfunction or Do Not ground to a gas pipe. - Page 4 Drain hose IMPORTANT: THIS PROCEDURE • Open clamp and push end of drain connection: MUST BE FOLLOWED TO hose onto drain connector until ASSURE PROPER hose contacts ribbed stop. Run water INSTALLATION. • Place clamp over area marked through “clamp”. Release clamp. both faucets into a bucket to get Standpipe or...
-
Page 5: Installation
Both numbers are on the model/serial rating plate located under the washer lid and on the top of the washer. Part No. 8318342 Benton Harbor, Michigan 49022 Printed in U.S.A. © 2000 Whirlpool Corporation...