Advertisement
Quick Links
Download this manual
See also:
Use and Care Manual
Insta|iation
©©
[mst_||er:
Leave Installation
Instructions
with
the homeowner,
Hemeowner:
Keep Instaihtion
Instructions
for future
reference.
Save
InstaIhtion
Instructions
for tocaI electrical
inspector's
use.
Your safety and the safety, of others are very important.
We have provided many important safety messages in this manua[ and on
your appliance. Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you
and others.
Aii safety messageswiii foiiow the safety alert symbol and either the word
"DANGER" or "WARNING". These words mean:
You can be killed or seriously injured if
you don't immediate[2follow instructions.
You can be killed or seriously injured if
you don't follow instructions.
All safety messageswill telI you what the potential hazard is, tetl you how to
reducethe chance of injury, and tell you what can happen if the instructions
are not followed.
Open lid and remove parts from
inside washer. Check that all parts
were included,
4 fiat water
hose washers
drain hose damp
yellow damp
2 front
leveling
legs
literature
pack
with nuts
(inside washer
Too|s needed:
_ge
[eve[
adjustable
wrench
or
9/16
open-end
wrench
Advertisement
Related Manuals for Whirlpool 3XLSQ7533JQ4
Summary of Contents for Whirlpool 3XLSQ7533JQ4
- Page 1 Your safety and the safety, of others are very important. Insta|iation We have provided many important safety messages in this manua[ and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
-
Page 2: Location Of Washer
Location of washer: C.eo iooa.oo you h ave everyth,ng necessary where washer w,,, be,nsta,ed. Make sure for correct installation. Proper imtalIation is your responsibilRy. ao. cold Recessed area (nstructJons Should be within This washer may be installed in a recessed area or closet, 3-1/2 feet of upper The installation dimensions... - Page 3 [I QZCO)Z02] Level washer Cold water inlet valve X Attach inlet hoses to hot and cold water valves, Plug power supp_ cord into grounded outlet. Hot water inlet valve Attach inlet hoses Read and to water then faucets. remove [abel hose connection, Power cord is...
-
Page 4: Drain Hose
Drain hose Wet the inside end of the drain hose with tap water DO NOT USE ANY OTHER LUBRmCANT. Run wate_ Squeeze ears of drain hose clamp with pliers to open and place through i_'_'.' . _ R_,._ both faucets into clamp over the end of the drain hose. - Page 5 Both numbers are on the model/serial rating plate located under the washer lid and on the top of the washel: Part No. 395281 7 Rev. B © 2001 Whirlpool Corporation Benton Harbor, Michigan 49022 Printed in U.S.A.