Table of Contents
Advertisement
11: Connection target not found
In the case of [ ], is Camera Connect running?
• Establish a connection using Camera Connect (
In the case of [
• Start the EOS software and reestablish the connection (
In the case of [
• Turn on the printer.
Are the camera and the access point set to use the same password for
authentication?
• This error occurs if the passwords do not match when the authentication method for
encryption is set to [Open system].
Check upper- and lower-case letters, and make sure the correct password for
authentication is set on the camera (
12: Connection target not found
Is the power of the target device and access point on?
• Turn on the target device and access point, then wait a while. If a connection still
cannot be established, perform the procedures to establish the connection again.
], is the EOS software running?
], is the power of the printer on?
).
).
581
).
Advertisement
Table of Contents
