Fusion (Model XF)
Controller V4.5 & TRIAC Replacement
Controller Replacement Guide
Fusion
2015-03-08
Fusion IQ ( XF/XRF/XRF2)
Thermostat Disc (Selco) Replacement
1
1. Required Tools: Paper Clip
Fusion (Model XF)
Temperature Probe Replacement
2015-12-22
5
2. CAUTION: Turn off power and detach power cord
2
1
8
9
10
3. Insert the Paper Clip into the small hole on either
side of the housing
4. Press in the Paper Clip until two clicks are heard:
the first click releases the Controller bezel and the
second click ejects it from the housing as shown
Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals
3
2
6
7
3
4
5
12
6
14
13
11
4
Included Parts:
5. Repeat the process on the other side of housing
1. Controller
2. Controller Overlay
Tool List:
3. Temperature strips
4. Zip ties
5. TRIAC
#2 Phillips Head Screw Driver
6. Adapter Harness (older models only)
Ratchet with Phillips head driver
7. 9-Pin Connector (where applicable)
Scissors
Included Parts:
Pliers
1. Temperature Probe (P/N: 1-1272-1)
Required Tools:
Selco and heat shrink
`
8. Allen Wrenches (3/32" & 9/64")
Required Tools:
9. #2 Phillips Screwdriver
2. Allen Wrenches (3/32", 9/64")
7
10. #1 Phillips Screwdriver
6. Remove the old Controller and insert the new
15
3. Needle-Nose Pliers
11. 2mm Precision Flathead Screwdriver
replacement Controller
4. Scissors
12. Scissors
5. #2 Phillips Screwdriver
13. Wire Cutters (9-pin repair only)
6. 2mm Precision Flathead Screwdriver
14. Wire Strippers (9-pin repair only)
7. Electrical Tape
15. Permanent Marker (9-pin repair only)
CAUTION: Detach power cord before
proceeding
CAUTION: Detach power cord before
7. Press on the two latch points with your thumb until
proceeding
a click is heard; if the Controller bezel does not sit
flush with the housing plastic, it has not latched
Lower heater but do not lock into place, such
8. Plug in and turn on heat press to verify function
that it rests gently on lower platen
1-800-727-8520
Page 1 of 1
www.hotronix.com
2018-04-26
Page 1 of 5
Page 1 of 17
Need help?
Do you have a question about the Hotronix Fusion and is the answer not in the manual?
Questions and answers