Advertisement
Advertisement
Table of Contents
Related Manuals for Yard force LT G33A
Summary of Contents for Yard force LT G33A
- Page 1 LT G33A & LT G33W 40V CORDLESS LINE TRIMMER Original Instructions READ & UNDERSTAND INSTRUCTION MANUAL Save all warnings and instructions for future reference. Hotline: 1300 418 640 Monday/Friday: 9.00am to 4.30pm Saturday: 9.00am to 3.00pm Email: service@actionspares.com.au...
-
Page 3: Table Of Contents
LT G33A & LT G33W Original Instruction CONTENT Description of Product Parts Technical Specifications Intended Use Safety Information Assembly Adjustment Operation Storing and Maintenance Troubleshooting Warranty... -
Page 4: Description Of Product Parts
DESCRIPTION OF PRODUCT PARTS Fig 1 Fig 2... - Page 5 DESCRIPTION OF PRODUCT PARTS Parts List As shown in Fig 1&2 14. Trimmer Blade Safety button 15. Spool cover ON/OFF trigger switch Main handle 16. Line release button 17. Cutting line Dual Speed selector 18. Ribs for releasing spool cover Auxiliary handle Quick -action clamp lever 19.
-
Page 6: Technical Specifications
TECHNICAL SPECIFICATIONS Model LT G33A & LT G33W Nominal voltage of machine/battery No load speed 8000-12000min Cutting width 300/330 mm Cutting line dia. Ø1.6mm Net weight 5.7kg Guaranteed sound power level 96 dB(A) Battery pack Model AL G40A Battery capacity 4.0Ah... -
Page 7: Safety Information
SAFETY INFORMATION IMPORTANT Please read these instructions fully before assembling and operating. Description of symbols Symbols are used in this manual to attract your attention to possible risks. The safety sym- bols and the explications which accompany them must be perfectly understood. The warning themselves do not prevent the risks and cannot be a substitute for proper methods of avoiding accidents. - Page 8 SAFETY INFORMATION Warning Symbols on the charger Warning! Before any use, refer to the corresponding paragraph in the present manual. The charger is for indoor use only. Double insulation. Australian Regulatory Compliance Mark. Warning Symbols on the battery pack Batteries contain Li-ion, waste batteries should be sorted for eco-friendly. Do not dispose of waste batteries as unsorted municipal waste.
- Page 9 SAFETY INFORMATION GENERAL POWER TOOL SAFETY WARNINGS WARNING! Read all safety warnings and all instruc- tions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future refer- ence.
- Page 10 SAFETY INFORMATION Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. Do not abuse the cord. Never use the cord for carry- ing, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts.
- Page 11 SAFETY INFORMATION used for appropriate conditions will reduce personal injuries. Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents.
- Page 12 SAFETY INFORMATION Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures re- duce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool.
- Page 13 SAFETY INFORMATION Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire. When battery pack is not in use, keep it away from other metal objects, like paperclips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to another.
- Page 14 SAFETY INFORMATION terminal to another. Shorting the battery terminals together may cause burns or a fire. Do not expose battery pack to heat or fire. Avoid stor- age in direct sunlight. Do not subject battery pack to mechanical shock. In the event of battery leaking, do not allow the liquid to come into contact with the skin or eyes.
- Page 15 SAFETY INFORMATION create a risk of fire when used with another battery pack. 15. Do not use any battery pack which is not designed for use with the equipment. 16. Keep battery pack out of the reach of children. 17. Retain the original product literature for future refer- ence.
- Page 16 SAFETY INFORMATION tion and then the battery connection. Do not charge a leaking battery. Do not use chargers for works other than those for which they are designed. Before charging, ensure your charger is matching the local AC supply. For indoor use, or do not expose to rain. The charging device must be protected from mois- ture.
- Page 17 SAFETY INFORMATION is between 18 C and 24 C. Do not charge the battery pack in air temperatures below 0 C, or above 45 This is important as it can prevent serious damage to the battery pack. 18. Charge only battery pack of the same model provid- ed by manufacturer and of models recommended by manufacturer.
- Page 18 SAFETY INFORMATION 12. Never use replacement parts or accessories not pro- vided or recommended by the manufacturer. 13. Ensure that the battery pack has been removed be- fore checking ,cleaning or working on the machine and when it is not in use. 14.
-
Page 19: Assembly
ASSEMBLY Assembling the Flower protection As shown in Fig 4 Push the flower protection into motor housing, it provides protection for flowers and gar- den furniture. To remove it, pull it out. Fig 4 Flower protection Push Assembling Safety guard As shown in Fig 5&6 WARNING! The guard must be properly installed. -
Page 20: Adjustment
ADJUSTMENT Adjusting additional handle Lift the quick-action clamp lever to release the additional handle . Slide additional handle along the length of connecting rod to desired position and rotate to the desired angle. Fix the additional handle in place by pressing the quick-action clamp lever down . Adjusting cutting width Fig 7 As shown in Fig7... -
Page 21: Operation
OPERATION Charging the battery pack As shown in Fig10 NOTE! Remove the battery pack from the charger after it has been fully charged . NOTE! This battery pack has been shipped in a low charge condition,it should be fully charged before first use. NOTE! make sure the main voltage is the same as rating label which located on the charger. - Page 22 OPERATION The green LED light of the charger will flash continuously during normal charging. After charging is complete, you will hear a beep sound again, the green LED on the char- ger will be on and the four green lights of the battery pack will be on for 3-5 seconds then turn off.
- Page 23 OPERATION similar items can short battery packs and cause a fire or explosion Always unplug the charger when not in use and store in a dry secure place. Avoid charging or storing your battery in temperatures below 0°C and above 45°C . Cool down hot battery pack from a just-operated tool for approximately 30 minutes before at- tempting to recharge.
- Page 24 OPERATION The charger has hanging holes for convenient storage. Install screws in the wall 9.5cm apart. Use screws sufficiently strong to hold the combined weight of the charger and battery pack. Switching On/Off As shown in Fig 13 WARNING! Before operating the unit. remove stones, loose pieces of wood and other objects from the cutting area.
- Page 25 OPERATION Working Advice Cutting grass As shown in Fig 14&15 Always hold the trimmer at a safe distance from body and adopt a safe stance. Switch on the unit Hold the trimmer at an angle of about 20° to the ground and Guide the trimmer in a semi- circular motion around your standing position.
- Page 26 OPERATION Trimming Edges As shown in Fig 17 Guide the grass trimmer along the edge of the lawn. Avoid contacting with paved surfaces, stone or garden walls, as this will wear the cutting line rapidly. Use the edge of the guard as a guide when cutting near fences and walls, etc. Fig 17 TIPS For best results, do not cut wet grass because it tends to stick to the cutting head and...
- Page 27 OPERATION Fig 18 Spool cover Line spool Trimmer head WARNING! Never use steel, wire, rope, string, etc. which can break off and become a dangerous missile. Rest the unit by using with the support As shown in Fig19 There are two supports on the safety guard. When placing the unit on the flat surface , it can works as support to prevent it from wobbling.
-
Page 28: Storing And Maintenance
STORING AND MAINTENANCE WARNING! Before performing any repair work, always remove the battery pack and wait until the cutting line has come to a standstill! 1. Do not spray the unit with water. Ingress of water may destroy the battery pack and the electric motor. -
Page 29: Troubleshooting
TROUBLESHOOTING Troubleshooting WARNING! Before performing any repair work, always remove the battery pack and wait until the cutting line has come to a standstill. CAUTION! Improper repairs can result in the product functioning unsafely. This endangers your- self and your environment. Faults which cannot be rectified with the aid of following table may be rectified by a specialist company only (customer service center). -
Page 30: Warranty
WARRANTY The mower is covered by a 2 year parts and labour warranty against manufacturing defects. The battery pack and charger are covered by a 1 year parts and labour warranty against manufacturing defects. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.