Whirlpool TGR51WO Use And Care Manual page 25

PROBLEM POSSIBLE CAUSE
SOLUTION
Burner flames
Burner ports are clogged.
Clean with a straight pin (see pages
are uneven 18 and 22). If this fails, call an
authorized Whirlpool@ service techni-
cian for service.
Burner flames
lift off ports,
are yellow, or
are noisy
when turned
Off
Air/gas mixture is incorrect.
Contact an authorized Whirlpool
service technician to check air/gas
mixture.
Burner makes Burner is wet from washing.
Let dry.
popping noise
when on
Control
knob(s) will
not turn
You are not pushing in before
Push control knob(s) in before
turning. turning to a setting.
Cooking
results are
not what you
expected
The range is not level. Level range. (See Installation Instruc-
tions.)
The oven temperature seems
Adjust the oven temperature control.
too low or too high. (See "Adjusting the oven temperature
control" on page 13.)
The oven was not preheated
as the recipe calls for.
Preheat oven if called for in recipe.
The recipe has never been Use only tested recipes from a
tested or is not from a reliable
reliable source.
source.
The pans are not the type or
size recommended in the
recipe.
Refer to a reliable cookbook for
recommended pan type and size.
There is not proper air
circulation around pan when
baking.
Allow 1 l/z to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Flame size does not fit the
cooking utensil being used.
When broiling, you have not
completely closed the broiler
drawer.
Adjust flame size to fit cooking
utensil.
Completely close broiler drawer.
25