Failure Codes And What To Do In Case Of Failure - BORETTI M-system MVW-600 Operating Instructions Manual

Failure codes and what to do in case
of failure
ERROR CODE
P1 P2 P3
(Intensive) (Economic) (Quick) (Prewash)
If the programme won't start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned
on.
• Be sure that you have closed the machine
door.
• Be sure that you switched off the machine by
pressing the Power On / Off button.
• Be sure that the water inlet filter and the
machine filters are not clogged.
If detergent residues are left in the detergent
compartment
Detergent has been added when the detergent
compartment was wet.
ERROR DESCRIPTION
P4
Inadequate water supply.
Error of continious water
input.
The waste water in
the machine cannot be
discharged.
Intended water tempera-
ture could not be reached
faulty heater and heater
sensor.
Alarm is active against
water overflow.
Faulty electronic card.
If water is left inside the machine at the end of
the programme
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The programme is not finished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
If shaking and hitting noises are heard during a
wash operation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.
CONTROL
• Make sure the water input tap is
totally openand that there is no
water cut.
• Close the water input tap, separate
the water input hose from the tap
and clean the filter at the connec-
tion end of the hose.
• Restart your machine, contact the
service if the error resumes.
• Close the tap
• Contact the service
• Water discharge hos is clogged.
• The filter of your machine might be
clogged.
• Power off-on your machine and
activate the program cancellation
command.
• Contact the service
• Power off your machine and close
the tap.
• Contact the service
• Contact the service
D
EN
49