Electrical Connection; Prior To Using The Machine; Den - BORETTI M-system MVW-600 Operating Instructions Manual

lable), the water can be drained directly into
the sink via hooking the bent pipe over the edge
of the sink.
This connection should be at a minimum of 50
cm and and at a maximum of 110 cm from the
floor plane.
Warning: When a drain hose longer than 4 m
is used, the dishes might remain dirty. In that
case, our company will not accept responsibi-
lity.

Electrical connection

The earthed plug of your machine should be
connected to an earthed outlet supplied by sui-
table voltage and current. If there is no earthing
installation, have a competent electrician carry
out an earthing installation. In case of usage
without earthing installed, our company will not
be responsible for any loss of usage that might
occur. The indoor fuse current value should be
Water outlet 10-16 A.
hose Your machine is set according to 220-240 V. If
The water drain the mains voltage in your location is 110 V, con-
hose can be con- nect a transformer of 110/220 V and 3000 W
nected either inbetween. The machine should not be plugged
directly to the in during positioning.
At low voltage, Wash efficiency of your machine
water drain hole
decreases. Always use the coated plug supp-
or to the sink
lied with your machine.
outlet spigot.
Using a special The machine's electrical cable should be repla-
bent pipe (if avai- ced by an authorised service or an authorised
electrician only. Failure to do so may lead to
accidents. For safety purposes, always make
sure to disconnect the plug when a wash pro-
gramme is finished. In order not to cause an
electric shock, do not unplug when your hands
are wet.
When disconnecting your machine from the
mains supply, always pull from the plug. Never
pull the cord itself.
Prior to using the machine for the first time
• Check whether the electricity and supply
• Remove all packaging materials inside the
• Set the water softener.
• Add 2 kg salt into the salt compartment and
• Fill the rinse aid compartment.
water specifications match the values indi-
cated by the installation instructions for the
machine.
machine.
fill with water up to a level at which it will
almost overflow.
D
EN
35