Whirlpool SF3020EG Use & Care Manual page 20

CARING FOR YOUR RANGE
L -
IFT UP COOKTOP AND SURFACE BURNERS
1.
Remove the surface burner grates.
2.
Lift the front of cooktop at both front corners
3.
Wipe the surface under the cooktop with warm,
4.
Wipe off the surface burners with warm, soapy
20
until the support rods
lock into place.
NOTE: Do not drop the
cooktop. Damage could
result to the porcelain
and the cooktop frame.
soapy water and a
sponge. Use a soap-
filled plastic scrubbing
pad on heavily soiled
areas.
water and a sponge
after each use. To
remove cooked-on
food, soak the burners
in a vinegar and water
solution for 20-30
minutes. Then scrub
them with a plastic
scrubbing pad. (See the
"Cleaning chart" section
for more information.)
5.
Check the burner flames once in a while for proper
Ports
1 "
2
or see the Installation Instructions.
6.
If the ports are clogged, clean with a straight
7.
To lower the cooktop, lift the cooktop from both
8.
Replace the surface burner grates.
size and shape as shown.
A good flame is blue in
color. If flames lift away
from ports, are yellow,
or are noisy, turn off the
burner. Allow the burner
to cool and follow Step 6.
If you still have a problem,
contact an authorized
service technician to
check the air/gas mixture
pin. DO NOT enlarge
or distort the ports.
DO NOT use a tooth-
pick to clean the ports.
Toothpick pieces may
clog the ports.
sides while pressing the
support rods back to
unlock them. Lower the
cooktop into place.