Oven Vent; Lighting Standing Pilots - Whirlpool SF3007SR Use & Care Manual

Whirlpool gas range use&care guide sf300bsr, sf3007sr
Table of Contents

Advertisement

The Oven Vent
Hot air and moisture escape
from the
oven through
a vent located
under
the backguard.
Do not block vent.
Poor baking
will result.
OVEN VENT
Lighting Standing Pilots
To light Cooktop Pilots:
1.
Remove the surface
burner grates
from the cooktop.
Lift the cooktop
and rest on support
rod.
2. Make sure all controls
are OFF.
To Light Oven Burner Pilot:
1.
Make sure the oven control
is OFF.
2. Remove the broiler drawer. Slide
drawer
out to stops, lift both sides,
then slide the rest of the way out.
3. To light,
hold a lit match over the
pilot light located
between
the
front and back burners. The pilot
flame should be Y4 to 3/e in
(635.953
cm) high.
4. If the pilot flame needs adjust-
ment, turn the pilot adjustment
screw on the manifold
pipe.
5. Lower the cooktop
and replace
the surface
burner grates before
using the surface
burners.
3. Hold a lit match over the oven
burner pilot located
at the rear of
the burner.
4. After the oven burner pilot is burn-
ing steady, check
burner lighting
by turning the Oven Control to a
temperature
above
140°F (60°C).
The burner will take 50-60 seconds
to light.
5. Replace
the broiler drawer.
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sf300bsr

Table of Contents