Using The Oven Control; Baking - Whirlpool SF3000SW/EW Use And Care Manual

Using Your Range
Continued
8
3.
4.
5.
To light, hold a lit match over the
pilot light located between the front
and back burners. The pilot flame
should be i/4 to 3/6 in. (.6 - 1 cm)
high.
If the pilot flame needs adjustment,
turn the pilot adjustment screw
midway down the length of the
manifold pipe, under the control
panel.
Replace the cooktop and the grates
before using the surface burners.
To light oven burner pilot:
1.
2.
3.
4.
5.
Make sure the Oven Temperature
Control is OFF.
Remove the broiler drawer. Slide
drawer out to stops, lift both sides,
then slide the rest of the way out.
Hold a lit match over the oven burner
pilot located at the rear of the burner.
After the oven burner pilot is burning
steadily, check burner lighting by
turning the Oven Temperature
Control to a temperature above
140°F (60°C). The burner will take
50-60 seconds to light.
Replace the broiler drawer.
Using the oven control
Baking
1. Position the rack(s) properly before
turning on the oven. To change rack
position, pull rack out to stop, raise
front edge and lift out.
The rack(s) should be placed so
the top of the food will be centered in
the oven. Always leave at least 1 l/2
to 2 inches (4-5 cm) between the
sides of the pan and the oven walls
and other pans. For more informa-
tion, see the Cooking Guide.