Related Manuals for Vislink DragonFly
Summary of Contents for Vislink DragonFly
- Page 1 DragonFly with Remote Control Quick Guide Quick Guide DragonFly with Remote Control...
-
Page 2: Equipment Required
Antenna, Miniature, WIFI/ZigBee, Dual Band, MMCX MALE 921-B424-01A-R Cable, BNC Male to MMCX Plug, RG-316 Coax, 12 inch 922-B1269-01A-R Cable, 8-P Power Conn to Bare Tinned Leads, 12", Dragonfly 922-B1270-01A-R Cable, 8-P Power Conn to 2-P Molex, 12", Dragonfly 922-B1264-01A-R Cable, 7.4VDC Tenergy Battery to 2-P Molex, 6", Dragonfly V3... - Page 3 DragonFly with Remote Control Quick Guide 9013335 Cable - FCDF to Antenna - LMR-400 10ft Serial cable XLR to DB9 with USB to serial adaptor USB Stick USB stick with RC application and user guide 1.3. DragonFly Connectors Table 1-2: DragonFly Connectors...
- Page 4 DragonFly with Remote Control Quick Guide 2. The newly modified Focal Point DragonFly will be damaged if >15VDC is applied. It must not be used with the original power supply. The new power supply is a 12VDC supply.
- Page 5 DragonFly with Remote Control Quick Guide Figure 2-1: DF with Remote Control Set-up.
-
Page 6: Operation
DragonFly with Remote Control Quick Guide Operation 1. Power up DragonFly using the batteries supplied or an external power supply. Do not apply more than 13VDC. 2. Power up Focal Point DragonFly with power supply furbished with the unit. 3. Install the Vislink Remote Control (VRC) application onto laptop from USB stick. - Page 7 DragonFly with Remote Control Quick Guide d. Enter each DF transmitter by pressing the ‘Add Transmitter’ button and entering a DF name or serial number plus picking the channel from the drop down list. Since the DFs have been pre-programmed, enter as shown above.
- Page 8 DragonFly with Remote Control Quick Guide 7. Setting a new parameter a. All parameters may be set by using a button, text box or drop down. b. Multiple parameters may be changed at the same time. c. The frequency is entered in ‘Hz’...
-
Page 9: Remote Control Application
DragonFly with Remote Control Quick Guide Figure 3-4: Saved Presets 10. Sending commands to multiple transmitters. a. Check all the boxes you want to send the RC command to. b. Press the ‘Affect Selected Transmitters’ button. c. Wait for the parameters to load. - Page 10 The section allows you to add transmitters be name (above shows by serial number) and to choose the channel. Each transmitter must be configured for its each individual channel using the Wi-Fi local interface. The Dragonfly’s channel cannot be programmed from the VRC application. The Manage Transmitter section includes: 1.
- Page 11 DragonFly with Remote Control Quick Guide Table 4-1: Remote Control Commands Available Control Activator Description Frequency Text Box Enter the frequency in Hz Power Buttons Standby, Low or High power buttons - push to activate Modulation Type Buttons DVB-T or LMST - push to activate...