Table of Contents
Advertisement
Installation
The following figure illustrates a typical example of device operation with Smart Save and Schedule
modes. Note that in Smart Save mode, the consumption is reduced by taking advantage of excess PV
earlier in the day.
To enable the Dry-Contact switch functionality, the following supporting devices must be installed:
Device Control ZigBee Module, installed inside the inverter. For physical installation refer to
l
http://www.solaredge.com/sites/default/files/se-device-control-zigbee-module-installation-
guide.pdf.
SolarEdge Modbus Meter. Refer to
l
installation-guide.pdf
Installation
2
Figure 2: Examples of device operation
http://www.solaredge.com/files/pdfs/solaredge-meter-
Figure 3: The Dry-Contact switch
SolarEdge Dry-Contact switch Installation Guide
Advertisement
Table of Contents
