Whirlpool RJE-3020 Use & Care Manual page 7

ReceDtacle
To remove surface
unit. lift and pull
stralght out.
Hold surface unit level
when replacing.
Removing surface units and reflector bowls:
1. First. be sure the Surface Unit Controls are all "OFF" and that the
surface units are cool.
2. Lift each surface unit about an inch (2.5 cm) at the edge away from the
plug-in (receptacle). Pull the unit straight away from the plug-in.
Do
not
wash surface
units: they will burn themselves clean during normal
USC?
3. Lift out the reflector bowls.
Replacing reflector bowls and surface units:
1
Be sure the surface unit controls are on "OFF,"
Put the reflector bowls back into their places. Make sure you can see
the plug-ins (receptacles) for the surface units through the square
hole in the side of each bowl.
Hold the surface unit level with the prongs (terminals) pointing at
the plug-in.
With the prongs started in the plug-in. start pushing in on the surface
unit. At the same time, lift a little on the side of the surface unit that's
by the plug-in.
Make sure the surface-unit prongs are pushed into the plug-in as far as
they will go. The surface unit should fit into the reflector bowl and be
level
7