Whirlpool RF385PXY5 Use And Care Manual page 36

Replacing
1. Make sure all surface units are off and
cool before replacing surface units,
reflector bowls and trim rings.
2. Line
up
openings in the reflector bowl
and notches in the trim ring with the
surface unit receptacle and the element
hold-down clip.
3.
(Model RF385PXY,
Q series, shown)
Hold the surface unii as level as pos-
sible with the terminal just started into
the receptacle. Push the surface unit
terminal into the receptacle.
4. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of
the surface unit
opposite the receptacle. The element
hold-down clip will keep the surface unit
from moving around.
NOTE: Reflector bowls reflect heat back to
the utensils on the surface units. They also
help catch spills. When they are kept clean,
they reflect heat better and look new
longer.
If a reflector bowl or trim ring gets discol-
ored, some of your utensils may not be flat
enough, or some may be too large for the
surface unit. In either case, some of the
heat that's meant to go into or around a
utensil goes down and heats the reflector
bowl or trim ring. This extra heat can
discolor it.
36