Download
Share
Print this page
Award CS1-903S Instruction Manual
  1. Manuals
  2. Brands
  3. Award Manuals
  4. Ventilation Hood
  5. CS1-903S
  6. Instruction manual

Award CS1-903S Instruction Manual

Hide thumbs

Advertisement

Quick Links

 
 
CS1-903S 
Range Hood 
Instruction Manual
 
 
 
 
 
 
 
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the CS1-903S and is the answer not in the manual?

Questions and answers

Related Manuals for Award CS1-903S

Summary of Contents for Award CS1-903S

  • Page 1     CS1-903S  Range Hood  Instruction Manual              ...

  • Page 2: Table Of Contents

    Version No.: V20200710    Content 1…………………………………..………………………………Safetyinstructions 2…………………………………..………………………………Installation 3…………………………………..………………………………Startusingyourrangehood 4…………………………………..………………………………Troubleshooting 5…………………………………..………………………………Maintenanceandcleaning 6…………………………………..………………………………Environmentprotection  ...

  • Page 3: SafetyInstructions

      SAFETY INSTRUCTIONS     hismanualexplainstheproperinstallationanduseofyourrangehood,please readitcarefullybeforeusingevenifyouarefamiliarwiththeproduct.The manualshouldbekeptinasafeplaceforfuturereference. Nevertodo: Alwaystodo: ● ● o not try to use the range hood mportant! Always switch off the without the grease filters or if the filters electricity supply at the mains during are excessively greasy! installation and maintenance such as light bulb replacement.
  • Page 4 Alwaystodo: Alwaystodo: ● ● lways put lids on pots and pans aution: The range hood and its when cooking on a gas cooker. accessible parts can become hot during operation. Be careful to avoid ● hen in extraction mode, air in the touching the heating elements.

  • Page 5: Installation

    INSTALLATION (VENT OUTSIDE)  INSTALLATION If you have an outlet to the outside, your range hood can be connected as below picture by means of an extraction duct (enamel, aluminium, flexible pipe or non- flammable material with an interior diameter of 150mm) 1. Before installation, turn the unit off and unplug it from the outlet. 2.
  • Page 6 Pic 3 5. Fix the outside chimney bracket on the outside chimney with 2pcs ST4*8mm screws, and be sure that the inside chimney can be adjusted to the required height freely. Install the chimney on the range hood and lead the expansion pipe to the outside. See Pic4.
  • Page 7   HINTS FOR EXHAUST DUCT INSTALLATION  The following rules must be strictly followed to obtain optimal air extraction: • Keep expansion pipe short and straight. • Do not reduce the size or restrict the expansion pipe. • When using the expansion pipe always install the pipe pulled taut to minimize pressure loss.

  • Page 8: StartUsingYourRangeHood

        Start Using Your Range hood Touch control with LED display  1. Press the “Power” button, the button controls “on” & “off” of the range hood. 2. Press the button “Speed” time after time, the motor runs as low / mid / high / low / mid…, the speed runs circularly; and the LED display will indicate as 1-2-3-1-2… circularly.

  • Page 9: Troubleshooting

    TROUBLESHOOTING Fault  Possible Cause  Solution  Fan switch turned off Select a fan switch position. Light on, but motor Fan switch failed Contact service center. does not work Motor failed Contact service center. House fuses blown Reset/Replace fuses. Light does not Refit mains power cable to work, motor does Mains power cable is loose or power outlet.
  • Page 10 STAINLESS STEEL The stainless steel must be cleaned regularly (e.g. weekly) to ensure a long life expectancy. Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may be used. NOTE: Ensure wiping is done along with the grain of the stainless steel to prevent any unsightly crisscross scratching patterns from appearing.
  • Page 11 CARBON FILTER-not supplied Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be changed every 3 to 6 months according to your cooking habits. The installation procedure of activated carbon filter is as below: 1.
  • Page 12 LED LIGHTS:  Remove the grease filter.  Way 1. Use a tool or the hand to press the spring clip of both sides of LED light to the inside, until the light is pressed out, see pic 1.Then slightly pull the light connecting wire out, and dismantle the terminal of the light connecting wire.

  • Page 13: EnvironmentProtection

    ENVIRONMENTAL PROTECTION:  This product is marked with the symbol on the selective sorting of waste electronic equipment. This means that this product must not be disposed of with household waste but must be supported by a system of selective collection in accordance with Directive 2012/19/EU.
  • Page 14   The  Warranty  covers  rectifications  of  faults  arising  from  defective  materials,  components,  faulty  workmanship  or  assembly.  The  product  will  be  repaired  or  replaced  at  the  sole  discretion  of  Award  Appliances (NZ) Ltd.    Conditions of Warranty:  The  purchaser/installer  carefully  follows  the  installation  instructions  provided  and  complies  with  electrical,  gas, ...