Advertisement
Quick Links
Advertisement
Related Manuals for Award PPS902SI
Summary of Contents for Award PPS902SI
- Page 1 Instructions Manual PPS902SI...
-
Page 2: Table Of Contents
INDEX RECOMMENDATIONS AND SUGGESTIONS ........................3 CHARACTERISTICS ................................6 INSTALLATION..................................7 USE ......................................9 MAINTENANCE ................................... 10... -
Page 3: Recommendations And Suggestions
(not applicable to appliances that only discharge the air back into the room). • In the event of damage to the power cable, it must be replaced by the manufacturer or by an Award authorised service centre, in order to prevent any risks. - Page 4 • If the instructions for installation for the gas hob specify a greater distance specified above, this has to be taken into account. Regulations concerning the discharge of air have to be fulfilled. • Use only screws and small parts in support of the hood. Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
- Page 5 • “CAUTION: Accessible parts may become hot when used with cooking appliances.” MAINTENANCE • Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. • Clean and/or replace the Filters after the specified time period (Fire hazard). •...
-
Page 6: Characteristics
CHARACTERISTICS Dimensions 650 mm 650 Components Ref. Q.ty Product Components Hood Body, complete with :Controls, Light, Blower, Filters Directioned grid Reducer Flange ø 150-120 mm Damper ø 150 mm Ref. Q.ty Installation Components Screws 2,9 x 9,5 Q.ty Documentation Instruction Manual... -
Page 7: Installation
INSTALLATION Fitting the Hood canopy BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS: • Remove grease filters. • Disconnect the wires to the Commands at the connectors. • Disconnect the wires to the Light at the connectors. •... - Page 8 Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. To install a ø 150 pipe ø...
-
Page 9: Use
Control panel Button Function Display Turns the suction motor on and off at speed one. Displays the set speed Decreases the working speed. Displays the set speed Increases the working speed. Displays the set speed Displays HI and the time remaining once every second. Activate intensive speed from any other speed, including motor off. -
Page 10: Maintenance
MAINTENANCE REMOTE CONTROL (OPTIONAL) The appliance can be controlled using a remote control powered by a 1.5 V carbon-zinc alkaline batteries of the standard LR03- AAA type (not included). • Do not place the remote control near to heat sources. •... - Page 11 • Remove the saturated charcoal filter by releasing the fixing hooks. • Fit the new filter and fasten it in its correct position. • Replace the Metal grease filters. Lighting unit • For replacement contact an authorised Award service centre.
- Page 12 991.0514.800_02 - 170719 D0003853_01...
Need help?
Do you have a question about the PPS902SI and is the answer not in the manual?
Questions and answers