May.2002
ERROR MESSAGES
When data are not processed properly or when other problems occur, an error
message appears. When an error message appears, take the following actions.
MIDI Error
Cause 1: Power of the MIDI device connected to the MIDI IN connector may
have failed.
Action 1: The SD-80 is not the problem. Confirm the power of the MIDI device
connected.
Cause 2: The MIDI cable may be pulled off, or broken.
Action 2: Check the MIDI cable.
MIDI Error !!
Cause: MIDI communication is not done properly. An overrun, framing or
parity error may have occurred.
Action: Check if the MIDI transfer rate of the MIDI device connected to the SD-
80 is proper. If this error message appears even after the above action, there
may be a problem with the SD-80's CPU. Check the CPU circuit and related
circuits of the SD-80.
MIDI Buffer full
Cause: Since a large amount of MIDI data was received in a short time,
processing could not be done.
Action: Check if a large amount of MIDI data was sent in a short time.
USB Off Line
Cause 1: Power of the computer connected to the USB connector may have
failed.
Action 1: The SD-80 is not the problem. Confirm the power of the computer
connected.
Cause 2: The USB cable may be pulled off, or broken.
Action 2: Check the USB cable.
Check Sum Error
Cause: Checksums of the exclusive messages received disagreed
Action: Check the contents of the data sent to the SD-80, and send them again.
Make sure that the MIDI cable is not broken.
SysEx Data error
Cause: The exclusive messages received contain errors.
Action: Check the contents of the data sent to the SD-80, and send them again.
41