Turning On The Projector - NEC PX2000UL User Manual

2-3. Turning on the Projector

NOTE:
• The projector has two power switches: A main power switch and a POWER button (POWER ON and POWER ON on the remote
control)
• Turning on the projector:
1. Press the main power switch to the ON position (I).
The projector will go into standby mode.
2. Press the POWER button .
The projector will become ready to use.
• Turning off the projector:
1. Press the POWER button.
The confirmation message will be displayed.
2. Press the POWER button again.
The projector will go into standby mode.
3. Press the main power switch to the OFF position (O).
The projector will be turned off.
1. Remove the lens cap from the lens unit.
NOTE:
• Do not leave the lens cap on the lens while the projector is
operating. The lens cap could get hot and become warped.
2. Press the main power switch to the ON position ( I ).
POWER indicator lights up in green. (When the [STANDBY
POWER] is set to [ON] in the on-screen menu)
(→ page 63)
2. Projecting an Image (Basic Operation)
15