Table of Contents
Advertisement
Adjusting with the remote control
1. Hold the CTL button and press the ECO/L-SHIFT button.
The [LENS CONTROL] screen will be displayed.
2. Press the ▼▲◀ or ▶ button.
Use the ▼▲◀▶ buttons to move the projected image.
NOTE:
About [CENTER LENS]
If the power of the projector is wrongly shut down during the motion of lens shift, it may shift the home position of the lens and
may cause of malfunction. The STATUS indicator flashed in Orange to inform this kind of trouble occurrence. In this case, perform
[CENTER LENS].
Operating procedure
1. Power on the projector.
2. Press the (HOME) button on the control panel or keep pressing the CTL button and press the INFO/L-CALIB. button on the remote
control.
[CENTER LENS] is executed.
TIP:
• The diagram below shows the lens shift adjustment range (projection mode: [DESKTOP FRONT]). To raise the projection position
higher than this, adjust by the tilt foot. (→ page 25)
* NP45ZL only ± 45% V
Description of symbols: V indicates vertical (height of the projected image), H indicates horizontal (width of the projected image).
15%H
50%V*
100%V
50%V*
100%H
15%H
22
2. Projecting an Image (Basic Operation)
15%H
Width of projected image
Height of projected image
15%H
Advertisement
Table of Contents
