Janus V2 HD Product Manual page 19

Before your camera is ready to be used, it must be prepared. The following steps
will guide you in preparing your SD.
FORMATTING SD CARD WITH CAMERA
If you are using a new 32GB SD card or lower, insert SD card into camera while the camera
is powered OFF. Once the SD is secured in the camera, you can then power it ON and a
voice prompt will notify you that the SD is being formated. This should take about 1
minute. Once formatting is complete, camera will beep once and all 3 lights should stay
solid. Card is now formatted and ready for all configurations.
*USED SD cards:
If you are using a SD card that has been used, you will first need to format the SD card. Follow
directions below.
SD CARD SIZE:
I. 32GB and lower: You can either use the camera OR viewer software to format SD
cards lower than 32GB.
- Select the Setup icon on the bottom of the viewer software indicated with the
cross wrench and hammer. Then select the fourth tab labeled Removable Disk.
Under the Select Drive box, make sure to select the drive in which the SD card is in
then press Format Drive. Your SD card will now have a folder labeled config.
II. Higher than a 32GB (64-128GB): SD cards higher than 32GB will not format
properly with the viewer software nor with the computer. Please contact a sales rep
when using a 32GB SD card or higher. Special formatter required. (Example
illustrated below)
After your SD card has been formatted, you
are ready to make your configurations.
NOTE: Make sure after making your
configuration changes, you are saving it in the
SD card drive, in the
First Use & Card Formatting
config
folder.
13