Panasonic WV-Q126A Operating Instructions Manual page 12

Step 10
Mount the camera mount bracket (accessory
to the camera) or base unit (component of the
camera) on the camera mounting stage.
When the camera mount bracket is used:
Align the g FRONT mark of the camera
mount bracket with the g FRONT mark at
the side where the cables are not passed
of the camera mounting stage.
When the base unit is used:
Align the direction that the cables of the
base unit exit with the
where the cables of the camera mounting
stage are passed.
Use M4 screws (accessories) to secure the
camera mount bracket or base unit at 4 points.
(Recommended tightening torque: 1.57 N·m
{1.16 lbf·ft})
Lay the cables between the mounting chassis
and camera mounting stage, and leave the
cables hanging down.
When the base unit is mounted, connect the
cables from the ceiling to the cables from the
base unit.
Note:
• The selection between the base unit and
camera mount bracket depends on the
camera type.
The base unit is a component of the cam-
era, and the camera mount bracket is an
accessory to the camera.
• The camera mount bracket is attached in
figures shown in the following descriptions.
Camera mounting
stage
mark
Paper gauge
Camera mount
bracket
12
mark at the side
gFRONT mark
Screws (M4) x4 (accessory)
Step 11
Connect the cables to the camera, engage the
camera with the camera mount bracket so that
the bottom center of the camera is aligned with
the center of the camera mount bracket as
shown in the drawing below, align the lock
plate with the guide, and rotate the camera
clockwise by approx. 20 degrees when viewing
it from beneath to temporarily secure the cam-
era.
* Refer to the installation guide of the camera
for details on how to install the camera.
Important:
• Do not let the cables be caught during
installation work.
• Be sure to mount it with holding the base
part of the camera. Mounting the camera
while holding the dome part may result in
malfunction.
Guide
Lock plate
Base part of the
camera