Table of Contents
Advertisement
SERVSHIELD
3.5 Fan Assembly
The fan assembly is already installed in the rear door. The part number for the rear fan filter is RM475. If you
need to replace a filter, follow these steps:
1. Replace one filter at a time. The twelve screws, which hold the filters in place, are the only thing holding
the fan assembly on. If you replace one filter at a time, you won't have to remove the fan assembly.
2. Remove the fan filter cover—it snaps off.
3. Remove the four #8-32 x
4. Replace the filter, using the same four #8-32 x
5. Replace the fan filter cover.
6. Repeat steps 2 through 5 for the remaining two filters.
Rear Door
Fan Filter Cover
3.6 Replacing the Door Filter
You can easily remove the filter on the front door to clean or replace it. The part number for the front door
filter is RM476. To remove the filter, remove the two wing nuts on the top of the filter, swing the filter bracket
down and remove the filter.
The life of the filter depends on the environment the ServShield is installed in. You can vacuum the filters or
wash them in warm water with mild detergent. We recommend vacuuming the filter to keep it in peak
condition. If you choose to wash the filter, do so only once and replace it with a new filter when it gets dirty
again.
6
3
⁄
" screws holding the filter on the door.
4
3
⁄
" screws.
4
#8-32 x
3
⁄
" self-drilling
4
and tapping screws (12)
Figure 3-2. Replacing a Fan Filter.
Fan Assembly
Fan Grill (3)
Advertisement
Table of Contents
