Table of Contents
Advertisement
3.1 Leveling the Cabinet
The ServShield cabinets are shipped with both casters and leveling glides for your convenience. Two casters
have brakes that you can activate by turning the brake level located on the side of the wheel. You can lower the
leveling legs by turning the leveling glide to the proper height using a
3.2 Removing the Doors
The top and bottom front doors and the rear door are removable. To remove a door, open the door beyond 90
degrees. Then grasp the door with both hands, and carefully lift upward. When the door is free of the hinge
pins, pull the door away from the enclosure. To attach the door, align all of the hinges (two on the front doors
and three on the rear door) and slowly slide the door down until seated.
3.3 Removing the Side Panels
The side panels are secured to the enclosure frame with eight #10-32 Phillips head screws per side panel. To
remove the side panels, remove the eight #10-32 screws from the inside of the cabinet. The side panel should
separate enough to pull it away from the frame. If it doesn't, lightly push from the inside of the cabinet to
separate it from the frame. Reverse the process to re-install the side panel.
3.4 Power Strip Mounting
Mounting brackets are located in the left and right rear corners of the enclosure for mounting a vertical power
strip. The slots on the rear of the power strip will slide onto the brackets. Once seated against the screw head in
the bracket, bend one of the bracket's fingers to secure the power strip to the frame (see Figure 3-1).
Bend this finger
to secure the
power strip to
the frame
3. Installation
Figure 3-1. Mounting the Power Strip.
3
⁄
" open-ended wrench.
4
Bracket for
power strip
Power strip
SERVSHIELD
5
Advertisement
Table of Contents
