Fujitsu LifeBook P1610 Technical Procedure

Fingerprint sensor replacement

Hide thumbs Also See for LifeBook P1610:

LifeBook P1610

Fingerprint Sensor Replacement

ESD Precautions are required when working on this LifeBook computer.

Make sure the LifeBook is turned off before beginning this procedure.

1. Turn the LifeBook over and

remove the battery

3. Extract 8 screws from the front of

the display.

2. Remove 8 screw covers from the

front of the display.

4. Using the plastic pry tool pry

around the perimeter of the display

to release the front cover from the

rear.

Table of Contents

Do you have a question about the LifeBook P1610 and is the answer not in the manual?

Page 1 LifeBook P1610 Fingerprint Sensor Replacement ESD Precautions are required when working on this LifeBook computer. Make sure the LifeBook is turned off before beginning this procedure. 1. Turn the LifeBook over and 2. Remove 8 screw covers from the remove the battery front of the display.
Page 2 5. Gently slide the pry tool between 6. Lift the front cover off. the screen and the front cover to release the tape. 7. Extract 2 screws from the 8. Disconnect the cable from the Fingerprint Sensor board. board and lift it out. 9.
Page 3 13. Lift the display up and turn it 14. Lay it back down and turn the around. LifeBook over. 15. Replace the battery.