Operation, Storage&Maintenance; Maintenence; Lubrication; Making A Non-Through Cut - TACKLIFE MTS01A User Manual

EN
OPERATION, STORAGE&MAINTENANCE

Making a non-through cut

Non-through cuts can be made with the grain (ripping) or across the grain (cross cut). Non-through
cuts are needed for cutting grooves or rabbets. This is the only type of cut that the blade gets covered
by the workpiece and is made without the blade guard and anti-kickback finger assemblies installed.
Make sure the blade guard and anti-kickback finger assemblies are reinstalled after this type of cut is
done.
For non-through cuts, position the riving knife in the "down" position, set the blade to the correct
height.Turn on the saw and allow the blade to come up to speed, use push stick to feed workpiece
into blade.

MAINTENENCE

WARNING: For your own safety, turn switch "off" and remove plug from power source outlet before
maintaining or lubricating your saw.
Do not allow sawdust to accumulate on the saw. Frequently blow any dust that may accumulate under
the saw and the motor. Clean your cutting toots with a Gum and Pitch Remover. The cord and tool
should be wiped with a dry clean cloth to prevent deterioration from oil and grease.
WARNING: Certain cleaning agents and solvents can damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents
which contain ammonia. Avoiding use of these and other types off cleaning agents will minimize the
possibility of damage.
A coat of automobile type wax applied to the table will help keep the surface dean and allow
workpieces to slide more freely. If the power cord is worn or cut, or damaged in any way, have it
replaced immediately. Make sure the teeth of the ANTI-KICKBACK fingers are always sharp. To
sharpen:
1. Remove anti-kickback fingers assembly from the riving knife.
2. Use a small round file (Smooth Cut) to sharpen the teeth.
WARNING: All repairs, electrical or mechanical, should be attempted only by trained may create a
Hazard.

LUBRICATION

The table saw has sealed lubricated bearings in the motor housing and the arbor assembly,they will
not require any additional lubrication.
- 6 -