Westfalia 961151 Instruction Manual page 23

Learning the lantern, Type ED102
To send the command signal, hold
the lantern and the motion detector
close together. Hold the learning
key of the lantern pressed (prefera-
bly from the side) and observe the
built-in LED.
1. Press the learning key as long
as the LED starts flashing. Now
you have totally 30 seconds to
emit the command.
2. Press the contact switch on
the bottom side of the mo-
tion detector until the LED of
the lantern starts glimmering
and than turns off. This
indicates that the command
is emitted.
3. If the lantern continuously
flashed after learning proc-
ess, it indicates that either the
batteries of the motion detec-
tor are spent or that the rear
cover of the motion detector is
not tightened. As long as the
rear cover is not screwed the
motion detector will emit a
signal to the lantern.
Learning
Learning Key
Contact Switch
18